Categories

IGS-20040MT – Planet 16-Port Industrial Gigabit Switch with 4-Port SFP

Part Number: IGS-20040MT Categories , , ,

A fully-managed Gigabit fiber switch specifically designed for the industrial network. It features 16 10/100/1000BASE-T copper ports, 4 100/1000BASE-X SFP ports and a redundant power system in an IP30, rugged but compact-sized case that can be installed in any difficult environment without space limitation. It provides user-friendly yet advanced IPv6/IPv4 management interfaces, abundant L2/L4 switching functions and Layer 3 static routing capability.

Physical Port

  • 16-Port 10/100/1000BASE-T RJ45 copper
  • 4 100/1000BASE-X mini-GBIC/SFP slots, SFP type auto detection
  • One RJ45 console interface for basic management and setup

Industrial Case and Installation

  • IP30 aluminum case
  • DIN-rail and wall-mount design
  • Redundant power design
    – 9 to 48V DC, redundant power with polarity reverse protect function
    – AC 24V power adapter acceptable
  • Supports EFT protection for 6000V DC power and 6000V DC Ethernet ESD protection
  • -40 to 75 degrees C operating temperature

Digital Input and Digital Output

  • 2 digital input (DI)
  • 2 digital output (DO)
  • Integrates sensors into auto alarm system
  • Transfers alarm to IP network via email and SNMP trap

Layer 2 Features

  • High performance of Store-and-Forward architecture and runt/CRC filtering eliminates erroneous packets to optimize the network bandwidth
  • Storm Control support
    – Broadcast/multicast/unknown unicast
  • Supports VLAN
    – IEEE 802.1Q tagged VLAN
    – Up to 255 VLANs groups, out of 4095 VLAN IDs
    – Provider Bridging (VLAN Q-in-Q) support (IEEE 802.1ad)
    – Private VLAN Edge (PVE)
    – Protocol-based VLAN
    – MAC-based VLAN
    – Voice VLAN
  • Supports Spanning Tree Protocol
    – IEEE 802.1D Spanning Tree Protocol (STP)
    – IEEE 802.1w Rapid Spanning Tree Protocol (RSTP)
    – IEEE 802.1s Multiple Spanning Tree Protocol (MSTP) by VLAN- BPDU Guard
  • Supports Link Aggregation– 802.3ad Link Aggregation Control Protocol (LACP)- Cisco ether-channel (static trunk)- Maximum 10 trunk groups, with 8 ports per trunk group- Up to 16Gbps bandwidth (duplex mode)
  • Provides port mirror (many-to-1)
  • Port mirroring of the incoming or outgoing traffic on a particular port
  • Loop protection to avoid broadcast loops
  • Supports E.R.P.S. (Ethernet Ring Protection Switching)
  • IEEE 1588 and synchronous Ethernet network timing

Quality of Service

  • Ingress Shaper and Egress Rate Limit per port bandwidth control
  • 8 priority queues on all switch ports
  • Traffic classification
    – IEEE 802.1p CoS
    – IP ToS, DSCP, IP precedence
    – IP TCP/UDP port number
    – Typical network application
  • Strict priority and Weighted Round Robin (WRR) CoS policies
  • Supports QoS and in/out bandwidth control on each port
  • Traffic-policing policies on the switch port
  • DSCP remarking

Multicast

  • Supports IPv4 IGMP snooping v1, v2 and v3
  • Supports IPv6 MLD snooping v1 and v2
  • Querier mode support
  • IGMP snooping port filtering
  • MLD snooping port filtering
  • MVR (multicast VLAN registration)

Security

  • Authentication
    – IEEE 802.1x port-based and MAC-based network access authentication
    – Built-in RADIUS client to cooperate with the RADIUS servers
    – TACACS+ login users access authentication
    – RADIUS/TACACS+ users access authentication
  • Access Control List
    – IP-based Access Control List (ACL)
    – MAC-based Access Control List
  • Source MAC/IP address binding
  • DHCP snooping to filter untrusted DHCP messages
  • Dynamic ARP Inspection discards ARP packets with invalid MAC address to IP address binding
  • IP Source Guard prevents IP spoofing attacks
  • Auto DoS rule to defend DoS attack
  • IP address access management to prevent unauthorized intruder

Layer 3 IP Routing Features

  • Supports maximum 32 static routes and route summarization

Management

  • IPv4 and IPv6 dual stack management
  • Switch management interfaces
    – Console/Telnet command line interface
    – Web switch management
    – SNMP v1, v2c, and v3 switch management
    – SSH/SSL secure access
  • IPv6 IP address/NTP/DNS management
  • Built-in Trivial File Transfer Protocol (TFTP) client
  • BOOTP and DHCP for IP address assignment
  • System Maintenance
    – Firmware upload/download via HTTP/TFTP
    – Reset button for system reboot or reset to factory default
    – Dual images
  • DHCP relay and DHCP option82
  • User privilege levels control
  • NTP (Network Time Protocol)
  • Link Layer Discovery Protocol (LLDP) and LLDP-MED
  • SFP-DDM (digital diagnostic monitor)
  • Network diagnostic
    – ICMPv6/ICMPv4 remote ping
    – Cable diagnostic technology provides the mechanism to detect and report potential cabling issues
  • SMTP/Syslog remote alarm
  • Four RMON groups (history, statistics, alarms and events)
  • SNMP trap for interfacing Link Up and Link Down notification
  • System log
  • PLANET Smart Discovery Utility for deployment management
Hardware Specifications
Copper Ports16 10/100/1000BASE-T RJ45 Auto-MDI/MDI-X ports
SFP Slots4 1000BASE-SX/LX/BX SFP interfaces (Port-17 to Port-20)
Compatible with 100BASE-FX SFP
Console1 x RJ45 serial port (115200, 8, N, 1)
Switch ArchitectureStore-and-Forward
Switch Fabric40Gbps/non-blocking
Throughput (packet per second)29.7Mpps@64Bytes
Address Table8K entries, automatic source address learning and ageing
Shared Data Buffer4Mbits
Flow ControlIEEE 802.3x pause frame for full duplex
Back pressure for half duplex
Jumbo Frame9Kbytes
SDRAM512Mbytes
Flash Memory64Mbytes
Reset Button< 5 sec: System reboot
> 5 sec: Factory Default
ConnectorRemovable 6-pin terminal block for power input
Pin 1/2 for Power 1; Pin 3/4 for fault alarm; Pin 5/6 for Power 2
Removable 6-pin terminal block for DI/DO interface
Pin 1/2 for DI 0 & DI 1; Pin 3/4 for DO 0 & DO 1; Pin 5/6 for GND
AlarmOne relay output for power failure. Alarm Relay current carry ability: 1A @ 24V AC
Digital Input(DI)2 Digital Input (DI):
Level 0: -24V~2.1V (±0.1V)
Level 1: 2.1V~24V (±0.1V)
Input Load to 24V DC, 10mA max.
Digital Output (DO)2 digital output:
Open collector to 24VDC, 100mA
EnclosureIP30 aluminum case
InstallationDIN-rail kit and wall-mount kit
Dimensions (W x D x H)76.8 x 107.3 x 152 mm
Weight1,043g
Power RequirementsDC 9V to 48V
AC 24V
Power Consumption8 watts/27BTU (System on)
17 watts/58BTU (Full loading)
ESD Protection6KV DC
LED IndicatorSystem:
Power 1 (Green)
Power 2 (Green)
Fault Alarm (Green)
Ring (Green)
R.O. (Green)
Per 10/100/1000T RJ45 Port:
1000 LNK/ACT (Green)
10/100 LNK/ACT (Orange)
Per SFP Interface:
1000 LNK/ACT (Green)
100 LNK/ACT (Orange)
Layer 2 Management Functions
Port ConfigurationPort disable/enable
Auto-negotiation 10/100/1000Mbps full and half duplex mode selection
Flow Control disable/enable
Power saving mode control
Port StatusDisplay each port’s speed duplex mode, link status, flow control status, auto negotiation status and trunk status.
Port MirroringTX/RX/Both
Many to 1 monitor
VLAN802.1Q tag-based VLAN, up to 255 VLAN groups
Q-in-Q tunneling
Private VLAN Edge (PVE)
MAC-based VLAN
Protocol-based VLAN
Voice VLAN
MVR (Multicast VLAN Registration)
Up to 255 VLAN groups, out of 4095 VLAN IDs
Link AggregationIEEE 802.3ad LACP/Static Trunk
Support 10 groups of 8-port trunk support
Spanning Tree ProtocolIEEE 802.1D Spanning Tree Protocol
IEEE 802.1w Rapid Spanning Tree Protocol
IEEE 802.1s Multiple Spanning Tree Protocol
IGMP SnoopingIPv4 IGMP (v1/v2/v3) Snooping
IPv4 IGMP Querier mode support
Up to 255 multicast Groups
MLD SnoopingIPv6 MLD (v1/v2) Snooping
IPv6 MLD Querier mode support
Up to 255 multicast Groups
Access Control ListIP-based ACL/MAC-based ACL
ACL based on:
– MAC Address
– IP Address
– Ethertype
– Protocol Type
– VLAN ID
– DSCP
– 802.1p Priority
Up to 256 entries
Bandwidth ControlPer port bandwidth control
Ingress: 500Mbps ~1000Mbps
Egress: 500Mbps ~1000Mbps
QoSTraffic classification based, strict priority and WRR
8-level priority for switching
– Port Number
– 802.1p priority
– 802.1Q VLAN tag
– DSCP/TOS field in IP Packet
SynchronizationIEEE 1588v2 PTP(Precision Time Protocol)
– Peer-to-peer transparent clock
– End-to-end transparent clock
Layer 3 Functions
IP InterfacesMax. 8 VLAN interfaces
Routing TableMax. 32 routing entries
Routing ProtocolsIPv4 software static routing
IPv6 software static routing
Switch Management
Basic Management InterfacesConsole; Telnet; Web browser; SNMP v1, v2c
Secure Management InterfacesSSHv2, TLS v1.2, SNMPv3
System ManagementFirmware upgrade by HTTP protocol through Ethernet network
Configuration upload/download through HTTP
Remote Syslog
System log
LLDP protocol
NTP
PLANET Smart Discovery Utility
SNMP MIBsRFC-1213 MIB-II
IF-MIB
RFC 1493 Bridge MIB
RFC 1643 Ethernet MIB
RFC 2863 Interface MIB
RFC 2665 Ether-Like MIB
RFC 2819 RMON MIB (Group 1, 2, 3 and 9)
RFC 2737 Entity MIB
RFC 2618 RADIUS Client MIB
RFC 2933 IGMP-STD-MIB
RFC 3411 SNMP-Frameworks-MIB
IEEE 802.1X PAE
LLDP
MAU-MIB
Standards Conformance
Regulatory ComplianceFCC Part 15 Class A, CE
Stability TestingIEC 60068-2-32 (free fall)
IEC 60068-2-27 (shock)
IEC 60068-2-6 (vibration)
Standards ComplianceIEEE 802.3 10BASE-T
IEEE 802.3u 100BASE-TX/100BASE-FX
IEEE 802.3z Gigabit SX/LX
IEEE 802.3ab Gigabit 1000T
IEEE 802.3x flow control and back pressure
IEEE 802.3ad port trunk with LACP
IEEE 802.1D Spanning Tree Protocol
IEEE 802.1w Rapid Spanning Tree Protocol
IEEE 802.1s Multiple Spanning Tree Protocol
IEEE 802.1p Class of Service
IEEE 802.1Q VLAN tagging
IEEE 802.1ad Q-in-Q VLAN stacking
IEEE 802.1X Port Authentication Network Control
IEEE 802.1ab LLDP
IEEE 802.3ah OAM
IEEE 802.1ag Connectivity Fault Management (CFM)
IEEE 1588 PTPv2
RFC 768 UDP
RFC 793 TFTP
RFC 791 IP
RFC 792 ICMP
RFC 2068 HTTP
RFC 1112 IGMP v1
RFC 2236 IGMP v2
RFC 3376 IGMP version 3
RFC 2710 MLD version 1
RFC 3810 MLD version 2
ITU-T G.8032 ERPS Ring
ITU-T Y.1731 Performance Monitoring
Environment
OperatingTemperature: -40 ~ 75 degrees C
Relative Humidity: 5 ~ 95% (non-condensing)
StorageTemperature: -40 ~ 85 degrees C
Relative Humidity: 5 ~ 95% (non-condensing)

 

SIMILAR PRODUCTS