Categories
FGSD-1008HPS – Planet 8-Port 30W PoE Switch with 2-Port Up Link and 2 Port SFP (120W)
PLANET FGSD-1008HPS provides 8 10/100BASE-T PoE ports, in-line power interfaces and two Gigabit TP/SFP Combo interfaces which support high-speed transmission of surveillance images and videos.
– PoE Port Power feeding priority
– Per PoE port power limit
– PD classification detection
– PoE Power sequential
Layer 2 Features
- Auto-MDI/MDI-X detection on each RJ45 port
- Prevents packet loss with back pressure (half-duplex) and IEEE 802.3x pause frame flow control (full-duplex)
- Supports broadcast storm control
- Supports VLAN
– IEEE 802.1Q tag-based VLAN, up to 30 VLANs groups, out of 4094 VLAN IDs
– Port-based VLAN, up to 10 VLAN groups
– MTU VLAN (Multi-tenant Unit VLAN)
- Supports Link Aggregation
– 802.3ad Link Aggregation Control Protocol (LACP)
– Cisco ether-channel (static trunk)
– Maximum 3 trunk / LACP groups, up to 4 ports per trunk / LACP group
- Supports Spanning Tree Protocol
– STP, IEEE 802.1D Spanning Tree Protocol
– RSTP, IEEE 802.1w Rapid Spanning Tree Protocol
- Port mirroring to monitor the incoming or outgoing traffic on a particular port, many-to-1
- Loopback protection to avoid broadcast loops
Quality of Service
- Ingress / Egress Rate Limit per port bandwidth control
- 2 priority queues on all switch ports
- Traffic classification
– Port-based priority
– IEEE 802.1p-based priority
– IP TOS / DSCP-based priority
– TCP / UDP port-based QoS
- Strict priority and Weighted Round Robin (WRR) CoS policies
Multicast
- Supports IGMP Snooping v1 and v2
Security
- Physical port to MAC address binding
- TCP/UDP port number filter: Forwarding or discarding typical network applications
Management
- Switch Management Interfaces
– Web switch management- SNMP v1 / v2c switch management
- Supports DHCP Option82 and DHCP Relay
- Firmware upload/download via HTTP
- Configuration upload/download through HTTP
- Hardware reset button for system reboot or reset to factory default
- PLANET Smart Discovery Utility
| Hardware Specifications | |
|---|---|
| 10/100Mbps Copper Ports | 8 10/100BASE-TX RJ45 Auto-MDI/MDI-X ports |
| Gigabit Copper Ports | 2 10/100/1000BASE-T RJ45 Auto-MDI/MDI-X ports |
| SFP/mini-GBIC Slots | 2 1000BASE-X SFP interfaces, shared with Port-9 to Port-10 |
| Switch Architecture | Store-and-Forward |
| Switch Fabric | 5.6Gbps / non-blocking |
| Throughput | 4.16Mpps@64Bytes |
| Address Table | 4K entries, automatic source address learning and ageing |
| Shared Data Buffer | 2.75Mb embedded memory for packet buffers |
| Flow Control | IEEE 802.3x pause frame for full-duplex Back pressure for half-duplex |
| Maximum Transmit Unit | 1536 Bytes |
| Reset Button | < 5 sec: System reboot > 5 sec: Factory default |
| Dimensions (W x D x H) | 330 x 155 x 43.5 mm, 1U height |
| Weight | 1.5kg |
| LED | System: Power (Green) 10/100BASE-TX RJ45 Interfaces (Port1 to Port8): 10/100Mbps LNK/ACT (Green) PoE In-Use (Orange) 10/100/1000BASE-T RJ45 / SFP Interfaces (Port 9 to Port10): LNK/ACT (Green) 100/1000 (Green) PoE Usage 30W, 60W, 90W, 120W (Orange) |
| Cable | Twisted-Pair 10BASE-T: 2-Pair UTP CAT. 3, 4, 5, up to 100 meters 100BASE-TX: 2-Pair UTP CAT. 5, 5e up to 100 meters 1000BASE-T: 4-Pair UTP CAT. 5e, 6 up to 100 meters Fiber-Optic Cable 1000BASE-SX : 50/125μm or 62.5/125μm multi-mode fiber optic cable, up to 550m (varying on SFP module) 1000BASE-LX : 9/125μm single-mode fiber optic cable, up to 10/20/30/40/50/60/70/120 kilometers (varying on SFP module) |
| Power Requirements | 100~240V AC, 50/60Hz, 2A |
| Power Consumption | Max. 150 watts / 511BTU |
| ESD Protection | Contact Discharge 8KV DC Air Discharge 8KV DC |
| Power over Ethernet | |
| PoE Standard | IEEE 802.3af / 802.3at PoE / PSE |
| PoE Power Supply Type | End-span |
| PoE Power Output | Per Port 52V DC, Max. 30.8 watts |
| Power Pin Assignment | 1/2(+), 3/6(-) |
| PoE Power Budget | 125 watts (max.) |
| PoE Ability | PD @ 7 watts 8 units PD @ 15.4 watts 8 units PD @ 30.8 watts 4 units |
| Layer 2 Functions | |
| Port Management | Port disable / enable Auto-negotiation 10/100/1000Mbps full and half duplex mode selection Flow Control disable / enable Bandwidth Control / Broadcast Storm Control |
| Port Status | Display each port’s speed duplex mode, link status, flow control status, auto negotiation status |
| Port Mirroring | TX / RX / Both Many-to-1 monitor |
| VLAN | 802.1Q tagged-based VLAN, up to 30 VLAN groups, out of 4094 VLAN IDs Port-based VLAN, up to 10 VLAN groups MTU VLAN |
| QoS | Allow to assign low / high priority on each port First-In-First-Out, All-High-before-Low, Weight-Round-Robin QoS policy |
| Security | Control MAC address binding TCP & UDP Filter |
| Spanning Tree Protocol | STP, IEEE 802.1D Spanning Tree Protocol RSTP, IEEE 802.1w Rapid Spanning Tree Protocol |
| Link Aggregation | 2 groups of 4-Port 10/100BASE-TX trunk supported 1 group of 2-Port 10/100/1000BASE-T trunk supported |
| DHCP Relay | DHCP Relay Agent / DHCP Relay Server |
| PoE Setting | PoE Status / PoE Port Setting / PoE Sequential |
| Configuration Back / Restore | Configuration backup / restore through Web interface |
| IGMP Snooping | IGMP (v1 / v2) Snooping, up to 32 multicast groups |
| Management Functions | |
| Basic Management Interfaces | Web browser, SNMP v1 / v2c |
| Standards Conformance | |
| Regulation Compliance | FCC Part 15 Class A, CE |
| Standards Compliance | IEEE 802.3 Ethernet IEEE 802.3u Fast Ethernet IEEE 802.3ab Gigabit Ethernet IEEE 802.3z Gigabit Ethernet IEEE 802.3x Full-duplex flow control IEEE 802.1Q VLAN IEEE 802.1p QoS IEEE 802.1D Spanning Tree Protocol IEEE 802.1w Rapid Spanning Tree Protocol IEEE 802.3af Power over Ethernet IEEE 802.3at Power over Ethernet Plus |
| Environment | |
| Operating | Temperature: 0 ~ 50 degrees C Relative Humidity: 5 ~ 95% (non-condensing) |
| Storage | Temperature: -10 ~ 70 degrees C Relative Humidity: 5 ~ 95% (non-condensing) |
