Back

IGS-20040MT – 16-Port Industrial Gigabit Switch with 4-Port SFP

Available on backorder

Part Number:IGS-20040MT

IN STOCK. Same day shipping available.

IP30 Industrial 16-Port Gigabit + 4-Port SFP Full Managed Ethernet Switch (-40 to 75 C)

Physical Port

  • 16-Port 10/100/1000BASE-T RJ45 copper
  • 4 100/1000BASE-X mini-GBIC/SFP slots, SFP type auto detection
  • One RJ45 console interface for basic management and setup

Industrial Case and Installation

    • IP30 aluminum case
    • DIN-rail and wall-mount design
    • Redundant power design

- 9 to 48V DC, redundant power with polarity reverse protect function- AC 24V power adapter acceptable

  • Supports EFT protection for 6000V DC power and 6000V DC Ethernet ESD protection
  • -40 to 75 degrees C operating temperature

Digital Input and Digital Output

  • 2 digital input (DI)
  • 2 digital output (DO)
  • Integrates sensors into auto alarm system
  • Transfers alarm to IP network via email and SNMP trap

Layer 2 Features

    • High performance of Store-and-Forward architecture and runt/CRC filtering eliminates erroneous packets to optimize the network bandwidth
    • Storm Control support

- Broadcast/multicast/unknown unicast

    • Supports VLAN

- IEEE 802.1Q tagged VLAN- Up to 255 VLANs groups, out of 4095 VLAN IDs- Provider Bridging (VLAN Q-in-Q) support (IEEE 802.1ad)- Private VLAN Edge (PVE)- Protocol-based VLAN- MAC-based VLAN- Voice VLAN

    • Supports Spanning Tree Protocol

- IEEE 802.1D Spanning Tree Protocol (STP)- IEEE 802.1w Rapid Spanning Tree Protocol (RSTP)- IEEE 802.1s Multiple Spanning Tree Protocol (MSTP) by VLAN- BPDU Guard

  • Supports Link Aggregation- 802.3ad Link Aggregation Control Protocol (LACP)- Cisco ether-channel (static trunk)- Maximum 10 trunk groups, with 8 ports per trunk group- Up to 16Gbps bandwidth (duplex mode)
  • Provides port mirror (many-to-1)
  • Port mirroring of the incoming or outgoing traffic on a particular port
  • Loop protection to avoid broadcast loops
  • Supports E.R.P.S. (Ethernet Ring Protection Switching)
  • IEEE 1588 and synchronous Ethernet network timing

Quality of Service

    • Ingress Shaper and Egress Rate Limit per port bandwidth control
    • 8 priority queues on all switch ports
    • Traffic classification

- IEEE 802.1p CoS- IP ToS, DSCP, IP precedence- IP TCP/UDP port number- Typical network application

  • Strict priority and Weighted Round Robin (WRR) CoS policies
  • Supports QoS and in/out bandwidth control on each port
  • Traffic-policing policies on the switch port
  • DSCP remarking

Multicast

  • Supports IPv4 IGMP snooping v1, v2 and v3
  • Supports IPv6 MLD snooping v1 and v2
  • Querier mode support
  • IGMP snooping port filtering
  • MLD snooping port filtering
  • MVR (multicast VLAN registration)

Security

    • Authentication

- IEEE 802.1x port-based and MAC-based network access authentication- Built-in RADIUS client to cooperate with the RADIUS servers- TACACS+ login users access authentication- RADIUS/TACACS+ users access authentication

    • Access Control List

- IP-based Access Control List (ACL)- MAC-based Access Control List

  • Source MAC/IP address binding
  • DHCP snooping to filter untrusted DHCP messages
  • Dynamic ARP Inspection discards ARP packets with invalid MAC address to IP address binding
  • IP Source Guard prevents IP spoofing attacks
  • Auto DoS rule to defend DoS attack
  • IP address access management to prevent unauthorized intruder

Layer 3 IP Routing Features

  • Supports maximum 32 static routes and route summarization

Management

    • IPv4 and IPv6 dual stack management
    • Switch management interfaces

- Console/Telnet command line interface- Web switch management- SNMP v1, v2c, and v3 switch management- SSH/SSL secure access

    • IPv6 IP address/NTP/DNS management
    • Built-in Trivial File Transfer Protocol (TFTP) client
    • BOOTP and DHCP for IP address assignment
    • System Maintenance

- Firmware upload/download via HTTP/TFTP- Reset button for system reboot or reset to factory default- Dual images

    • DHCP relay and DHCP option82
    • User privilege levels control
    • NTP (Network Time Protocol)
    • Link Layer Discovery Protocol (LLDP) and LLDP-MED
    • SFP-DDM (digital diagnostic monitor)
    • Network diagnostic

- ICMPv6/ICMPv4 remote ping- Cable diagnostic technology provides the mechanism to detect and report potential cabling issues

  • SMTP/Syslog remote alarm
  • Four RMON groups (history, statistics, alarms and events)
  • SNMP trap for interfacing Link Up and Link Down notification
  • System log
  • PLANET Smart Discovery Utility for deployment management
IGS-20040MT - 16-Port Industrial Gigabit Switch with 4-Port SFP
Hardware Specifications
Copper Ports 16 10/100/1000BASE-T RJ45 Auto-MDI/MDI-X ports
SFP/mini-GBIC Slots 4 1000BASE-SX/LX/BX SFP interfaces (Port-17 to Port-20) Compatible with 100BASE-FX SFP
Console 1 x RJ45 serial port (115200, 8, N, 1)
Switch Architecture Store-and-Forward
Switch Fabric 40Gbps/non-blocking
Throughput (packet per second) 25.6Mpps
Address Table 8K entries, automatic source address learning and aging
Shared Data Buffer 4Mbits
Flow Control IEEE 802.3x pause frame for full-duplex Back pressure for half-duplex
Jumbo Frame 9Kbytes
Reset Button < 5 sec: System reboot > 5 sec: Factory default
ESD Protection 6KV DC
EFT Protection 6KV DC
Enclosure IP30 aluminum case
Installation DIN rail kit and wall-mount kit
Connector Removable 6-pin terminal block for power input Pin 1/2 for Power 1; Pin 3/4 for fault alarm; Pin 5/6 for Power 2 Removable 6-pin terminal block for DI/DO interface Pin 1/2 for DI 0 & DI 1; Pin 3/4 for DO 0 & DO 1; Pin 5/6 for GND
Alarm One relay output for power failure. Alarm relay current carry ability: 1A @ 24V AC
DI/DO ■ 2 Digital Input (DI): Level 0: -24V~2.1V (±0.1V) Level 1: 2.1V~24V (±0.1V) Input load to 24V DC, 10mA max. ■ 2 Digital Output (DO): Open collector to 24V DC, 100mA (max.)
LED Indicator System: Power 1 (Green) Power 2 (Green) Fault Alarm (Green) Ring (Green) R.O. (Green) Per 10/100/1000T RJ45 Port: 1000 LNK/ACT (Green) 10/100 LNK/ACT (Orange) Per SFP Interface: 1000 LNK/ACT (Green) 100 LNK/ACT (Orange)
Dimensions (W x D x H) 107 x 72 x 152 mm
Weight 1043g
Power Requirements 9V to 48V DC 24V AC
Power Consumption 8 watts/27BTU (system on) 17 watts/57BTU (full loading)
Layer 2 Functions
Basic Management Interfaces Web browser; remote Telnet; SNMPv1, v2c; local console
Secure Management Interface SSH/SSL, SNMPv3
Port Configuration Port disable/enable Auto-negotiation 10/100/1000Mbps full and half duplex mode selection Flow Control disable/enable Power saving mode control
Port Status Displays each port’s speed duplex mode, link status, flow control status,auto negotiation status and trunk status.
Port Mirroring TX/RX/Both Many to 1 monitor
VLAN 802.1Q tagged-based VLAN, up to 255 VLAN groups Q-in-Q tunneling Private VLAN Edge (PVE) MAC-based VLAN Protocol-based VLAN Voice VLAN MVR (Multicast VLAN Registration) Up to 255 VLAN groups, out of 4095 VLAN IDs
Link Aggregation IEEE 802.3ad LACP/static trunk Supports 10 groups with 8 ports per trunk
QoS Traffic classification based, strict priority and WRR 8-level priority for switching - Port number - 802.1p priority - 802.1Q VLAN tag - DSCP/ToS field in IP Packet
IGMP Snooping IGMP (v1/v2/v3) snooping, up to 255 multicast groups IGMP querier mode support
MLD Snooping MLD (v1/v2) snooping, up to 255 multicast groups MLD querier mode support
Access Control List IP-based ACL/MAC-based ACL Up to 256 entries
Bandwidth Control Per port bandwidth control Ingress: 500 Mbps ~1000Mbps Egress: 500 Mbps ~1000Mbps
SNMP MIBs RFC-1213 MIB-II IF-MIB RFC 1493 Bridge MIB RFC 1643 Ethernet MIB RFC 2863 Interface MIB RFC 2665 Ether-Like MIB RFC 2819 RMON MIB (Groups 1, 2, 3 and 9) RFC 2737 Entity MIB RFC 2618 RADIUS Client MIB RFC 2933 IGMP-STD-MIB RFC 3411 SNMP-Frameworks-MIB IEEE 802.1X PAE LLDP MAU-MIB
Layer 3 Functions
IP Interfaces Max. 8 VLAN interfaces
Routing Table Max. 32 routing entries
Routing Protocols IPv4 software static routing IPv6 software static routing
Standards Conformance
Regulatory Compliance FCC Part 15 Class A, CE
Stability Testing IEC60068-2-32 (free fall) IEC60068-2-27 (shock) IEC60068-2-6 (vibration)
Standards Compliance IEEE 802.3 10BASE-T IEEE 802.3u 100BASE-TX/100BASE-FX IEEE 802.3z Gigabit SX/LX IEEE 802.3ab Gigabit 1000T IEEE 802.3x flow control and back pressure IEEE 802.3ad port trunk with LACP IEEE 802.1D Spanning Tree Protocol IEEE 802.1w Rapid Spanning Tree Protocol IEEE 802.1s Multiple Spanning Tree Protocol IEEE 802.1p Class of Service IEEE 802.1Q VLAN tagging IEEE 802.1x Port Authentication Network Control IEEE 802.1ab LLDP IEEE 1588v2 RFC 768 UDP RFC 793 TFTP RFC 791 IP RFC 792 ICMP RFC 2068 HTTP RFC 1112 IGMP version 1 RFC 2236 IGMP version 2 RFC 3376 IGMP version 3 RFC 2710 MLD version 1 FRC 3810 MLD version 2
Environment
Operating Temperature: -40 ~ 75 degrees C Relative Humidity: 5 ~ 95% (non-condensing)
Storage Temperature: -40 ~ 75 degrees C Relative Humidity: 5 ~ 95% (non-condensing)
Click here to open the datasheets